AQUAZONIC® AMPHI G2
Amphibious Pump (Wet or Dry Mount)
AMPHI is designed and built to provide reliable pumping performance. The Inverter Technology reduces energy consumption making it suitable for all day use, giving energy savings of up to 70% while retaining strong and consistent water flow.
- Inverter Technology. Energy savings of up to 70% while maintaining strong flowrate.
- Intelligent Motor-Overheat Protection. Prevents the pump from overheating due to pump running without water, stalling of impeller and surge of electrical current.
- Tough Attrition-Resistant Impeller. Wear-resistant and provides better performance.
- Replaceable Impeller. Allows for easy replacement to maintain high performance level.
INTELLIGENT OVERHEAT PROTECTION CIRCUIT
AMPHI features a special protection circuit that protects the motor from damages when the below cases happen:
- Anti-Dry Protection
In the event that the pump is removed from water, or under any situation whereby the pump is unable to draw water (running ‘dry’), the anti-dry protection will kick in. After the pump runs ‘dry’ for approximately 5 minutes, it will stop for a few seconds, and run again for few seconds. These stop and run cycle will repeat 5 times before the pump enters the stop-protection mode. Turn off the power, replace pump back into water or draw water into pump before restarting. Turn power on to use.
- Anti-Stall Protection
In the event that the impellor is stalled (jammed), the pump will enter the stop-protection mode. Turn off the power and remove the cause of the obstruction. Turn power on to use.
- Current-Surge Protection
In the event that the pump is affected by a sudden surge in electrical current (due to external factors) beyond the maximum operating current, the pump will enter the stop-protection mode. Turn off the power. Turn power on to use.
|Code No||Description||Max Output (L/H)||Power Consumption||Max Head (M)|
|WP066||Amphi 3500||3500 L/H||25W||3.0M|
|WP067||Amphi 5000||5000 L/H||45W||3.5M|
|WP068||Amphi 6500||6500 L/H||50W||4.0M|
|WP069||Amphi 8000||8000 L/H||75W||4.5M|
|WP070||Amphi 10000||10000 L/H||85W||5.0M|
|Inlet Size (mm)||Hostetail (ø21mm, ø26mm, ø33mm, ø40mm)|
|Outlet Size (mm)||Hostetail (ø21mm, ø26mm, ø33mm, ø40mm)|
To remove the Housing Strainer, press the left and right of the Housing Strainer till the hooks come loosen, then push downwards.
*This table serves as a general reference and attempts to present data as accurately as possible. Actual results may vary depending on conditions at place of installation.
Freshwater or Marine Aquarium, ponds, filtration systems, water circulation, aeration or applications that require constant and strong water flow.